Log In

Close Window

APC 300 Setup Wizard

The APC300 Setup Wizard is a Windows® based utility to set up and control the APC300 Antenna Controller. The program works with APC300 firmware versions 2.8 or later.

The Wizard also works with version 2.7 firmware but it does not support software disabling of the Polarization and SMARTRACK® table editing features. Versions 2.6 and lower do not support it.

You can download the file to your computer now or you can request the APC300 software on a 3.5" disk (part number: AE03M-D0029-001) by calling the Andrew Customer Support Center at 1-800-255-1479 or 708-349-3300.

System Requirements

• 486 or Pentium processor
• Windows® 95, 98 or NT
• 16 MB system memory
• 15 MB free hard drive space
• 3.5" floppy drive
• decompression software

APC300 MS_DOS Version 2.2 software was provided with all APC300 Antenna Programmable Controllers. If you have lost or damaged your original disk you can download replacement software. This program includes the ACU-LOG, SAVE/LOAD, and Ephemeris Data Input for the APC300 ACU.

You can download the file to your computer now or you can request the APC300 replacement software on a 3.5" disk (part number: AE01M-B0284) by calling the Andrew Customer Support Center at 1-800-255-1479 or 708-349-3300.

The Utility Program Users Guide provides step-by-step information required to set up and input satellite parameters for the APC300. View and print the APC300 Utility Program Users Guide.

The Installation and Upgrade Instruction provides basic information on installing the APC300 Setup Wizard. View and print the Installation and Upgrade Instructions for the APC300 Setup Wizard.